Subaru Crosstrek Service Manual: Dtc b2311 rear radar detect tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B2311 REAR RADAR DETECT TCM
DTC DETECTING CONDITION:
Automatic transmission fails.
TROUBLE SYMPTOM:
• All functions of BSD/RCTA stop.
• Fail icon is displayed in the combination meter LCD display.
• Failure-related notification is displayed for approx. two seconds on LCD display in the combination meter.
• AT OIL TEMP light blinks in the combination meter.
NOTE:
Check and replace the side that displayed the DTC.
| STEP | CHECK | YES | NO |
1.CHECK TRANSMISSION.
Check the transmission. Basic Diagnostic Procedure">
Is there any fault?
Perform the inspection according to the diagnosis of the transmission.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2311 REAR RADAR DETECT TCM">Go to Step 2.
2.CHECK BSD/RCTA.
1) Restore the vehicle to its original state.
2) Perform the Inspection Mode. Inspection Mode">
Is DTC B2311 displayed? (Current malfunction)
Replace the radar sensor. Radar Sensor">
Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
Dtc b2304 rear radar on-off switch stuck
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2304 REAR RADAR ON-OFF SWITCH STUCKDTC detecting condition:• BSD/RCTA ...
Dtc b2313 rear radar detect vdc
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2313 REAR RADAR DETECT VDCDTC DETECTING CONDITION:Vehicle dynamics control ...
Other materials:
Odometer
Type A
Trip knob
Type B
Trip knob (U.S.-spec. models)
Trip knob (except U.S.-spec. models)
This meter displays the odometer when
the ignition switch is in the "ON" position.
The odometer shows the total distance
that the vehicle has been driven.
If you press the trip knob ...
Inspection
FRONT SUSPENSION > Front Ball JointINSPECTION1. Check that there is no looseness by moving the upper and lower portions of front tire in an axial direction with the brake pedal depressed.• Looseness exists > Replace the ball joint assembly. Front Ball Joint > REMOVAL">2. Chec ...
Dtc p0113 intake air temperature sensor 1 circuit high bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0113 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH BANK 1DTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing o ...
