KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B2277 SUBMERGING CIRCUIT
DTC detecting condition:
When the water-submersion detection circuit integrated into the keyless access CM detects the water submersion.
Trouble symptom:
• The ignition can be turned ON, but cannot be turned OFF.
• Engine will not start.
CAUTION:
For replacement procedure of keyless access CM, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
STEP | CHECK | YES | NO |
1.CHECK LAN SYSTEM.
Inspect LAN system. Basic Diagnostic Procedure > PROCEDURE">
Is LAN system normal?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2277 SUBMERGING CIRCUIT">Go to Step 2.
Perform the inspection according to the diagnosis for LAN system.
2.CHECK SUBMERSION CONDITION.
Check the keyless access CM and environment of equipment, and check the harness for any trace of water submersion.
Is there any trace of water submersion?
Take necessary measures against water submersion and replace the keyless access CM. Keyless Access CM">
Replace the keyless access CM. Keyless Access CM">
Dtc p0038 a/f / o2 heater control circuit high bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0038 A/F / O2 HEATER CONTROL CIRCUIT HIGH BANK 1 SENSOR 2DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear ...
Models without multi function display
NOTE
For models with information display
(black and white), refer to "Information
display"
The U.S.-spec models are not equipped
with the multi function display. The other
models may be equipped with the multi
function display or not, depending on the
model.
Safety precautions
WARNING
Alw ...
Dtc b1660 passenger s airbag on indicator failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1660 PASSENGER’S AIRBAG ON INDICATOR FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Passenger’s airbag indicator is faulty.• Airbag control module is faulty.&b ...