Subaru Crosstrek Service Manual: Dtc b1760 occupant detection sensor mat

Diagnosis start condition:

Ignition voltage is 8 V to 16 V.

DTC detecting condition:

• Occupant detection sensor is faulty.

• Occupant detection sensor circuit is open, shorted between terminals, shorted to power supply or shorted to ground.

• Seat heater circuit is open.

• Occupant detection control module is faulty.

1.CHECK POOR CONTACT OF CONNECTORS.

Check for poor contact of connectors between the occupant detection control module and the occupant detection sensor.

Is there poor contact of connector?

When the connector is not fully connected, reconnect the connector correctly. Replace the faulty harness if the connector is faulty. (Replace the occupant detection harness or replace the occupant detection system (passenger’s & frame assembly)). Front Seat > DISASSEMBLY">

Replace the occupant detection system (passenger’s & frame assembly). Front Seat > DISASSEMBLY">

Dtc b1655 front buckle switch rh failure

Dtc b1761 occupant detection sensor mat liquid coating

Other materials:

Preparation tool
SEAT BELT SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOL• SUBARU SELECT MONITORILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Selec ...

Removal
LIGHTING SYSTEM > Tail/Stop Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combinatio ...

Dtc p0963 pressure control solenoid "a" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0963 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Engine speed increases abruptly, and can ...