Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b16f6 curtain airbag sensor rh recognition error

Subaru Crosstrek Service Manual / Airbag system (diagnostics) / Diagnostic chart with trouble code / Dtc b16f6 curtain airbag sensor rh recognition error

AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code

DTC B16F6 CURTAIN AIRBAG SENSOR RH RECOGNITION ERROR

Diagnosis start condition:

Ignition voltage is 10 V to 16 V.

DTC detecting condition:

Curtain airbag sensor RH is misinstalled.

Airbag CM is faulty.

CAUTION:

Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION">

STEPCHECKYESNO

1.REPLACE CURTAIN AIRBAG SENSOR (RH).

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2) Replace the curtain A/B sensor (RH) with a genuine sensor. Curtain Airbag Sensor > REMOVAL">

Does the warning light go off?

Finish the diagnosis.

Replace the airbag control module. Airbag Control Module > REMOVAL">

Dtc b16f5 side airbag sensor lh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F5 SIDE AIRBAG SENSOR LH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:& ...

Dtc b16f7 curtain airbag sensor lh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F7 CURTAIN AIRBAG SENSOR LH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting conditio ...

Other materials:

Electrical component location Location
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)TPMS & keyless entry CM or TPMS CM(2)Tire pressure warning light(3)Snap-in type transmitter• Model without keyless access with push button start• Model with keyless access with push button star ...

Dtc c1362 normal closing valve 2
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1362 NORMAL CLOSING VALVE 2DTC detecting condition:• Defective harness connector• Defective VDCH/U solenoid valveTrouble symptom:• ABS does not operate.• EBD does not ...

Electrical specification
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONTerminal No.ContentMeasured value and measuring conditionsRemarks1 — — — 2 — — — 3 — — — 4Ignition power supply10 — 13 V (when the ignition switch is ON) — 5GND0 V (always) ...

© 2016-2024 Copyright www.sucross.com