Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b16f4 side airbag sensor rh recognition error

AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code

DTC B16F4 SIDE AIRBAG SENSOR RH RECOGNITION ERROR

Diagnosis start condition:

Ignition voltage is 10 V to 16 V.

DTC detecting condition:

Side airbag sensor RH is misinstalled.

Airbag CM is faulty.

CAUTION:

Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION">

STEPCHECKYESNO

1.REPLACE SIDE AIRBAG SENSOR (RH).

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2) Replace the side A/B sensor (RH) with a genuine sensor. Side Airbag Sensor > REMOVAL">

Does the warning light go off?

Finish the diagnosis.

Replace the airbag control module. Airbag Control Module > REMOVAL">

Dtc b1638 curtain airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1638 CURTAIN AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condi ...

Dtc b16f5 side airbag sensor lh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F5 SIDE AIRBAG SENSOR LH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:& ...

Other materials:

Installation
GLASS/WINDOWS/MIRRORS > Rear Quarter GlassINSTALLATION1. Fabricate the cartridge nozzle tip as shown and set the sealant gun with the adhesive.(1)10 mm (0.39 in)(2)8 mm (0.31 in)(3)Sealant gun2. Smoothen and clean the adhesive surfaces of the glass - rear quarter and body using the same procedure ...

System temporary stop indicator due to reduced radar sensitivity
System temporary stop indicator due to reduced radar sensitivity This indicator appears when the detectability of the radar sensors is reduced. Once the condition is corrected, the system will recover from the temporary stop condition and the indicator will disappear. If the indicator ...

Inspection
VEHICLE DYNAMICS CONTROL (VDC) > VDC OFF SwitchINSPECTION1. Disconnect the VDC OFF switch connector.2. Check the resistance between the VDC OFF switch terminals.PREPARATION TOOL:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?3. Replace th ...

© 2016-2022 Copyright www.sucross.com