Subaru Crosstrek Service Manual: Dtc b16f2 front sub sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code
DTC B16F2 FRONT SUB SENSOR RH RECOGNITION ERROR
Diagnosis start condition:
Ignition voltage is 10 V to 16 V.
DTC detecting condition:
Front sub sensor (RH) is misinstalled.
CAUTION:
Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION">
| STEP | CHECK | YES | NO |
1.REPLACE FRONT SUB SENSOR.
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.
2) Replace the front sub sensor (RH) with a genuine sensor. Front Sub Sensor > REMOVAL">
Does the warning light go off?
Finish the diagnosis.
Replace the airbag control module. Airbag Control Module > REMOVAL">
Dtc b1618 front sub sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1618 FRONT SUB SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition: ...
Dtc b16f3 front sub sensor lh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F3 FRONT SUB SENSOR LH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:Fro ...
Other materials:
Dtc b1578 meter
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1578 METERDTC DETECTING CONDITION:• Except for C5 modelReference code incompatibility between combination meter and body integrated unit or communication failure between body integrated unit and ECM&bull ...
Electrical component location Location
EyeSight (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Stereo camera(5)EyeSight steering switch(9)Transmission control module (TCM)(2)VDC control module (VDCCM)(6)MFD (multi-function display)(10)Stop light and brake switch(3)Brake light relay(7)Body integrated unit(11)ECM(4)Combination ...
Clear memory mode Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATIONAfter repairing the occupant detection system, clear the DTCs stored in the airbag control module and the occupant detection control module.1. AIRBAG SYSTEM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» ...
