Subaru Crosstrek Service Manual: Dtc b1577 imm control module eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1577 IMM CONTROL MODULE EEPROM
DTC DETECTING CONDITION:
• Body integrated unit malfunctioning
• Failed to access ROM inside the body integrated unit.
CAUTION:
When the body integrated unit is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
| STEP | CHECK | YES | NO |
1.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is registration complete?
Finish the diagnosis.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1577 IMM CONTROL MODULE EEPROM">Go to Step 2.
2.PERFORM ECM REGISTRATION.
1) Perform the Clear Memory Mode. (ECM and body integrated unit) Clear Memory Mode">
2) Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is registration complete?
Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
Replace the body integrated unit. Body Integrated Unit">
Dtc b1576 egi control module eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1576 EGI CONTROL MODULE EEPROMDTC DETECTING CONDITION:• ECM malfunctioning• Failed to access ROM ...
Dtc b1578 meter
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1578 METERDTC DETECTING CONDITION:• Except for C5 modelReference code incompatibility between combinati ...
Other materials:
Dtc b1501 power supply system error detection
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTIONDTC detecting condition:Open or short in combination meter power supply circuitTrouble symptom:Defective operation of combination meterWiring diagram:Com ...
Dtc b11f2 front impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F2 FRONT IMPACT DEPLOYMENTDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is indicated when the front airbag module and the pretensioner are deployed.Once this DTC is displayed, the ...
Dtc c0071 no signal from steering angle sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0071 NO SIGNAL FROM STEERING ANGLE SENSORDTC detecting condition:Communication from steering angle sensor is faulty.Trouble symptom:• VDC does not operate.• EyeSight does not ope ...
