Subaru Crosstrek Service Manual: Dtc b1501 power supply system error detection

DTC detecting condition:

Open or short in combination meter power supply circuit

Trouble symptom:

Defective operation of combination meter

Wiring diagram:

Combination meter system Combination Meter System > WIRING DIAGRAM">

1.CHECK POWER SUPPLY CIRCUIT.

Turn the ignition switch to ON, and confirm that the illumination of combination meter lights.

Does the illumination light?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTION">Go to Step 2.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTION">Go to Step 3.

2.CHECK DTC.

Read the DTC of the combination meter using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is DTC B1501 a current malfunction?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTION">Go to Step 3.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTION">Go to Step 5.

3.CHECK FUSE.

1) Turn the ignition switch to OFF.

2) Check the fuse. Relay and Fuse">

Is the fuse OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTION">Go to Step 4.

Replace the defective fuse.

4.CHECK HARNESS.

1) Turn the ignition switch to OFF.

2) Disconnect the combination meter connector.

3) Using the tester, measure the voltage between terminals.

Connector & terminal

(i10) No. 20 (+) — Chassis ground (−):

(i10) No. 40 (+) — Chassis ground (−):

Is the voltage 8.5 — 16.5 V?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1501 POWER SUPPLY SYSTEM ERROR DETECTION">Go to Step 5.

Repair the open circuit of harness or replace harness.

5.CHECK CONNECTOR.

1) Turn the ignition switch to OFF.

2) Disconnect connectors.

Is there poor contact of connector?

Repair or replace the poor contact of connector.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b1507 external air temperature open/short-circuit detection

Dtc u0073 control module communication bus off

Other materials:

Removal
AIRBAG SYSTEM > Side Airbag ModuleREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">NOTE:Remove the passenger’s side by referring to driv ...

List
ENTERTAINMENT > Diagnostics with PhenomenonLIST1. AUDIO SYSTEMSymptomsReferencePower will not turn ON. Diagnostics with Phenomenon > INSPECTION">The screen freezes and does not accept any operation entry. Diagnostics with Phenomenon > INSPECTION">The screen is blacked out, o ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Oil Temperature SensorREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from t ...