HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN
DTC detecting condition:
Evaporator sensor circuit is open.
Trouble symptom:
Evaporator temperature is falsely recognized as low, and the compartment temperature is adjusted.
Wiring diagram:
Air conditioning system Air Conditioning System > WIRING DIAGRAM">
STEP | CHECK | YES | NO |
1.CHECK CONNECTOR.
1) Check the condition of connector connection.
2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is B1434 displayed?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN">Go to Step 2.
Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2.CHECK EVAPORATOR SENSOR.
1) Disconnect the evaporator sensor.
2) Short the evaporator sensor connector (B88).
3) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is B1435 displayed?
Replace the evaporator sensor. Evaporator > REMOVAL">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN">Go to Step 3.
3.CHECK HARNESS.
1) Restore the temporary shorted lines made in step 2.
2) Turn the ignition switch to ON.
3) Using the tester, measure the voltage between terminals.
Connector & terminal
(B88) No. 2 (+) — No. 1 (−):
Is the voltage 4.5 — 5.0 V?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN">Go to Step 4.
Repair or replace the open circuit of harness.
4.CHECK HARNESS (OPEN CIRCUIT).
1) Disconnect the connector from the A/C control panel.
2) Using a tester, check continuity between terminals.
Connector & terminal
(B88) No. 1 — (i88) No. 14:
(B88) No. 2 — (i88) No. 18:
Is there continuity?
Replace the A/C control panel. Control Panel > REMOVAL">
Repair or replace the open circuit of harness.
Rear towing hook
1. Take the towing hook and screwdriver
out of the tool bucket. Take the jack
handle out of the cargo area.
2. Pry off the cover on the rear bumper
using a screwdriver, and you will find a
threaded hole for attaching the towing
hook.
3. Screw the towing hook into the thread
hole unti ...
List
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Read Current DataLIST• Combination meter (models with normal meters)Items to be displayedUnit of measureContentNoteIG on trip numbertimesTime stamp information — IG on supply system — Time stamp information — past time after IG onmsTime stam ...
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearDISASSEMBLY1. Flatten the tab of the lock nut.2. Using the ST, counter the rotation of the reduction driven gear assembly, and remove the lock nut.ST1 18355AA000PULLEY WRENCHST2 18334AA000PIN SETST3 499987003SOCKET WRENCH ( ...