Subaru Crosstrek Service Manual: Dtc b1401 meter collation

DTC DETECTING CONDITION:

Reference code incompatibility between combination meter and body integrated unit

CAUTION:

When the combination meter is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

1.CHECK DTC.

Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is any of DTC B1407 or B1408 detected?

Perform the diagnosis according to the DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1401 METER COLLATION">Go to Step 2.

2.CHECK COMBINATION METER REGISTRATION.

Perform registration of combination meter. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is registration complete?

Currently, it is normal. (Combination meter registration is not complete.)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1401 METER COLLATION">Go to Step 3.

3.CHECK DTC.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is any of DTC B1407 or B1408 detected?

Perform the diagnosis according to the DTC.

Replace the combination meter. Combination Meter">

Diagnostic procedure with diagnostic trouble code (dtc)

Dtc b1571 reference code incompatibility (immobilizer cm to ecm)

Other materials:

Installation
EXTERIOR/INTERIOR TRIM > Cowl PanelINSTALLATIONCAUTION:Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.1. Install the cowl panel assembly.CAUTION:If the cowl panel assembly cannot be installed properly, do not hit or set it forcibly. The ...

Hazard warning flasher setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or " " switch to select the "Hazard Warning Flasher" item.Then push the button. 3. The current setting will be displayed. Push the button to enter the selection mode. 4. Select "O ...

Inspection
COMMUNICATION SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and check visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection conditionsSpecificationCircuit1 — 2Always1 M? or more1 — 2Apply ...