Subaru Crosstrek Service Manual: Dtc b1010 body control system (biu) malfunction

DTC DETECTING CONDITION:

System error in body integrated unit

TROUBLE SYMPTOM:

LAN communication immobilizer function may not be executed normally.

1.CHECK DTC.

Check DTC indicated by body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is B1010 current malfunction?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1010 BODY CONTROL SYSTEM (BIU) MALFUNCTION">Go to Step 2.

Temporary EEPROM access error occurred.

2.CHECK CONNECTOR.

1) Turn the ignition switch to OFF.

2) Disconnect the body integrated unit connector.

3) Connect the disconnected connectors.

4) Read the DTC of body integrated unit using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is B1010 current malfunction?

Replace the body integrated unit. Body Integrated Unit">

Temporary EEPROM access error occurred.

Dtc b1411 immobilizer antenna

Dtc b1011 battery control power supply

Other materials:

Dtc b2350 rear radar communication error between master and slave
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2350 REAR RADAR COMMUNICATION ERROR BETWEEN MASTER AND SLAVEDTC DETECTING CONDITION:• Defective harness for CAN communication between radar sensor LH and radar sensor RH ...

Control screen and audio panel
Select to display the audio source selection screen.  level settings" Turn to adjust volume. Press to turn the audio system on/off. Press to select an audio source. Refer to "Selecting an audio source" Press to display the sound setting screen. Refer to "Unit settings" ...

Warranties and maintenance
SUBARU warranties do not apply to vehicle damage or malfunction caused by trailer towing. If you use your vehicle to tow a trailer, more frequent maintenance will be required due to the additional load. (Refer to "Maintenance schedule under severe driving conditions" in the "Warranty and Ma ...