Subaru Crosstrek Service Manual: Dtc b1000 airbag ecu malfunction
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code
DTC B1000 AIRBAG ECU MALFUNCTION
DIAGNOSIS START CONDITION:
Ignition voltage is 10 V to 16 V.
DTC DETECTING CONDITION:
Airbag control module is faulty.
CAUTION:
Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION">
| STEP | CHECK | YES | NO |
1.CHECK DTC.
Read the DTC. (Current malfunction) Read Diagnostic Trouble Code (DTC)">
Is any of B1000, B1003, B1105, B1106, B1115, B1116, B1120, B1121, B1125, B1126, B1135, B1136, B1145, B1146, B1170, B1185, B1195, B1196 or B1199 displayed?
Replace the airbag control module. Airbag Control Module">
Perform the Clear Memory Mode. Clear Memory Mode">
Dtc b1146 airbag ecu malfunction
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1146 AIRBAG ECU MALFUNCTIONNOTE:Refer to DTC B1146 for details on DTC B1000. Diagnostic Chart with Trouble Code > DTC B1000 ...
Dtc b11e0 rollover deployment history
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11E0 ROLLOVER DEPLOYMENT HISTORYDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is i ...
Other materials:
Inspection
EyeSight > Switches and HarnessINSPECTION1. PRE-COLLISION BRAKE OFF SWITCH AND LANE DEPARTURE WARNING OFF SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit tester• Pre-collision brake OFF switchTerminal No.Inspection conditionsStandard10 — 8OFFApprox. 1 ...
Dtc p060a internal control module monitoring processor performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P060A INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCE ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)REMOVAL1. Disconnect the ground cable from battery.2. Remove the glove box. Glove Box > REMOVAL">3. Disconnect the connector from ECM.4. Remove the bolts and nuts, and remove the ECM. ...
