Subaru Crosstrek Owners Manual: Driving tips
- New vehicle break-in driving - the first 1,000 miles (1,600 km)
- Fuel economy hints
- Engine exhaust gas (carbon monoxide)
- Catalytic converter
- Periodic inspections
- Driving in foreign countries
- Driving tips for AWD models
- Off road driving
- Winter driving
- Loading your vehicle
- Vehicle capacity weight
- GVWR and GAWR (Gross Vehicle Weight Rating and Gross Axle Weight Rating)
- Roof rail
- Trailer hitch (dealer option)
- Trailer towing
Handling of radar sensors
Radar sensors
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
CAUTION
To ensure correct operation of the
BSD/RCTA, observe the following
precauti ...
New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do ...
Other materials:
Dtc b1695 door sensor lh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1695 DOOR SENSOR LH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front door impact sensor (LH) is faulty.If DTC AB is displayed, the circuit within the front door impact sensor (LH) i ...
Installation
LUBRICATION(H4DO) > Oil Level SwitchINSTALLATION1. Install the oil level switch and the clip (A) to the oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the engine mounting LH onto the en ...
Dtc p2419 evap system switching valve control circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2419 EVAP SYSTEM SWITCHING VALVE CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > ...
