Subaru Crosstrek Owners Manual: Driving tips
Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions may cause clutch damage.
Do not drive with your hand resting on the shift lever. This may cause wear on the transmission components.
When it is necessary to reduce vehicle speed due to slow traffic, turning corners, or driving up steep hills, downshift to a lower gear before the engine starts to labor.
On steep downgrades, downshift the transmission to 4th, 3rd or 2nd gear as necessary; this helps to maintain a safe speed and to extend brake pad life.
In this way, the engine provides a braking effect. Remember, if you "ride" (over use) the brakes while descending a hill, they may overheat and not work properly.
The engine may, on rare occasions, knock when the vehicle rapidly accelerates or rapidly pulls away from a standstill. This phenomenon is not an indication of a problem in your vehicle.
Shifting speeds
Recommended shifting speeds
The best compromise between fuel economy
and vehicle performance during
normal driving is ensured by shifting up
at the speeds listed in the following table.
Maximum ...
Continuously variable transmission
WARNING
Do not shift from the "P" or "N"
position into the "D" or "R" position
while depressing the accelerator
pedal. This may cause the vehicle
to jump forward or backward.
CAUTION
Observe th ...
Other materials:
Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. Remove the resistor assembly - daytime running light.CAUTION:The resistor ma ...
Dtc b14e3 air mix door actuator stepping motor circuit open (passenger)
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E3 AIR MIX DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPEN (PASSENGER)DTC detecting condition:Air mix door actuator stepping motor circuit is open.Trouble symptom:Temperature cannot be adjusted.Wiring d ...
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation
of the skid suppression function and
during activation of the traction control
function.
NOTE
The light may remain illuminated for
a short period of time after the engine
has been started, especially in cold
weather. This does not indicate ...
