Subaru Crosstrek Owners Manual: Driving range on remaining fuel
- U.S.-spec. models
- Except U.S.-spec. models
The driving range indicates the distance that can be driven taking into account the amount of fuel remaining in the tank and the average rate of fuel consumption.
When the low fuel warning light illuminates, the driving range display flashes for 5 seconds. (The display first switches to the driving range value if a different value was previously displayed.)
- U.S.-spec. models
- Except U.S.-spec. models
If the driving range is shown as "
",
there is only a tiny amount of fuel left in the
tank. You must refuel the vehicle immediately.
NOTE
The driving range on remaining fuel is only a guide. The indicated value may differ from the actual driving range on remaining fuel, so you must immediately fill the tank when the low fuel warning light illuminates.
Driving information display
Information display selection knob
With the ignition switch in the "ON"
position, each successive press of the
information display selection knob
switches the display in the following seq ...
Average fuel consumption
U.S.-spec. models
Except U.S.-spec. models
This display shows the average rate of
fuel consumption since the trip meter was
last reset.
Trip knob
Pressing the trip knob toggle ...
Other materials:
General diagnostic table Inspection
DIFFERENTIALS > General Diagnostic TableINSPECTIONSymptom or troublePossible causeRemedy1. Oil leakage(1) Worn, scratched, or incorrectly seated front or side oil seal. Scored, battered or excessively worn sliding surface of companion flange.Repair or replace.(2) Clogged or damaged air breather c ...
Driving tips for AWD models
WARNING
Always maintain a safe driving
speed according to the road and
weather conditions in order to
avoid having an accident on a
sharp turn, during sudden braking
or under other similar conditions.
Always use the utmost care in
driving - overconfidence because
you are driving ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• After installing the secondary speed sensor, adjust t ...
