Subaru Crosstrek Service Manual: Drain separator

Installation

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > CanisterINSTALLATION1. Install the canister to the vehicle using bolts and nuts.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. In ...

Assembly

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorASSEMBLYAssemble in the reverse order of disassembly.NOTE:Connect the quick connector as shown in the figure. ...

Other materials:

Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...

Inspection
DIFFERENTIALS > Rear Differential (T-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage and other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find ou ...

Reverse Automatic Braking (RAB) system ON/OFF setting
In the Subaru Ascent, when the select lever is moved into the "R" (Reverse) position, you gain access to customizable settings for the Reverse Automatic Braking (RAB) system directly through the center information display. This allows the driver to conveniently enable or disable key ...