Subaru Crosstrek Owners Manual: Door unlock selection function
The door unlock selection function makes the following operations possible.
- Unlocking the driver's door without unlocking any other doors (including the rear gate) when gripping the driver's door handle
- Opening the rear gate without unlocking any doors when pressing the rear gate opener button
The operational/non-operational setting for this function can be changed by a SUBARU dealer.
Operational:
- Only the driver's door will be unlocked when the driver's door handle is gripped.
- The rear gate will open, but the other doors will remain locked when the rear gate opener button is pressed.
Non-operational:
All doors and the rear gate will be unlocked when the driver's door handle is gripped.
The rear gate will open and all doors will be unlocked when the rear gate opener button is pressed.
opener button is pressed.
The factory setting (default setting) is set as "operational".
For further details, consult a SUBARU dealer.
NOTE
The setting can be changed by your SUBARU dealer. Contact your SUBARU dealer for details. Also, for models with the multi function display, the setting can be changed by operating the multi function display. For details, refer to "Keyless access setting (models with "keyless access with push-button start system")" 3-83.
Power saving function
The keyless access function will be
disabled in the following cases to protect
the access key battery and the vehicle
battery.
Case 1: When the keyless access function and the remote keyless en ...
Selecting audible signal operation
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off. For more details,
contact a SUBARU dealer.
N ...
Other materials:
Dtc u0101 lost communication with tcm
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Removal
AIRBAG SYSTEM > Side Airbag SensorREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
Preparation for date setting
Turn the ignition switch to the "ON"
position.
Push and hold the button to show
the selection screen.
After the selection screen is displayed,
operate the "
"
or "
" switch to show the
"Time/Date" item. Then, push the
button.
...