The
warning light illuminates if any door
(including the rear gate) is not fully closed.
This function is effective even if the ignition switch is in the "LOCK"/"OFF" or "ACC" position, or the key is removed from the ignition switch.
Always make sure this light is not illuminated before you start to drive.
Hill start assist warning light/Hill start assist OFF indicator light
All-Wheel Drive warning light (CVT models)Inspection
LIGHTING SYSTEM > Turn Signal Light & Hazard Light UnitINSPECTION1. Disconnect the connector of the turn signal & hazard unit.2. Measure the voltage between the turn signal & hazard unit connector and the chassis ground.Preparation tool:Circuit testerTerminal No.Inspection conditionsS ...
Preparation tool
CONTROL SYSTEMS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to “A ...
Screen Settings
After entering the "Screen Settings" menu,
select one of the following menus.
Welcome Good-bye Screen
The welcome screen/good-bye screens
can be activated or deactivated. Select
"On" to activate the screens. Select "Off"
to deactivate the screens.
Gauge Initial Movement
The movement of the m ...