EXTERIOR BODY PANELS > Rear Gate
DISPOSAL
1. REAR GATE DAMPER STAY
CAUTION:
Gas is colorless, odorless, and harmless. However, gas pressure may spray cutting powder or oil. Be sure to wear dust-resistant goggles.
1. Cover with a vinyl sack as shown in the figure.
(1) | Stay ASSY - rear gate |
(2) | Vinyl sack |
NOTE:
Prevent the vinyl sack from being caught by drill cutting edge.
2. Lift the body side slightly with piston rods fully extended, and secure the body side with vise.
Drill a hole of 2 to 3 mm (0.08 to 0.12 in) diameter at a point 6 to 196 mm (0.24 to 7.72 in) from the body side, and bleed the gas in the stay assembly - rear gate completely.
(1) | Door side |
(2) | Body side |
(3) | 196 mm (7.72 in) |
(4) | 6 mm (0.24 in) |
(5) | Piston rod |
(6) | Cylinder |
(7) | Portion to be drilled |
Electrical specification
EyeSight (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. STEREO CAMERATerminal No.ContentMeasuring conditionStandard(R137) No. 1 — — — (R137) No. 2 — — — (R137) No. 3 — — — (R137) No. 4 — — — (R137) No. 5 — — — (R137) No. 6 ←> Ch ...
Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...
Preparation tool
SPEED CONTROL SYSTEMS(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer ...