Subaru Crosstrek Service Manual: Disassembly

CAUTION:

The starter should be placed through a no-load test whenever it has been overhauled.

1. Disconnect the cable from the magnet switch assembly.

2. Remove the magnet switch assembly from the starter housing assembly.

3. Remove screws (A) of the brush holder assembly, and through bolts (B) on both sides, and remove the starter cover assembly.

4. Remove the brush holder assembly from the armature assembly.

NOTE:

Hold the brush with your fingers so that the brush spring does not come flying out.

5. Remove the armature assembly and yoke assembly from the starter housing assembly together as a single unit.

6. Separate the armature assembly and yoke assembly.

7. Remove the pinion gear from the internal gear assembly.

8. Remove seal rubber (A), plate (B), and seal rubber (C).

9. Lightly tap the starter housing assembly with a plastic hammer as shown in the figure, and remove the overrunning clutch, internal gear assembly, shaft and shift lever together as one unit.

10. Use the following procedures to remove the overrunning clutch from the shaft.

(1) Use an appropriate tool (such as a fit socket wrench), and remove the stopper from snap ring by lightly tapping the stopper with a plastic hammer.

(2) Remove snap ring (A) from the shaft, and remove stopper (B).

(3) Remove the overrunning clutch from the shaft.

11. Separate the internal gear assembly and shaft.

Removal

Inspection

Other materials:

Check engine warning light/Malfunction indicator light
CAUTION If the CHECK ENGINE light illuminates while you are driving, have your vehicle checked/repaired by your SUBARU dealer as soon as possible. Continued vehicle operation without having the emission control system checked and repaired as necessary could cause serious damage, which may n ...

Dtc p0601 internal control module memory checksum error
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0601 INTERNAL CONTROL MODULE MEMORY CHECKSUM ERRORDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:TCM ROM malfunctionSTEPCHECKYESNO1 ...

Stopping engine
Stop the vehicle completely. Move the select lever to the "P" position. Press the push-button ignition switch. The engine will stop, and the power will be switched off. WARNING Do not touch the push-button ignition switch during driving. When the push-button ignition switch is ...