Subaru Crosstrek Service Manual: Disassembly
SECURITY AND LOCKS > Ignition Key Lock
DISASSEMBLY
1. Remove the immobilizer antenna assembly or the ignition switch illumination. Immobilizer Antenna > REMOVAL">
2. Release the claws, and pull the key warning switch downwards to remove.
3. Remove the screws and remove the key lock solenoid.
4. Replace the key cylinder.
(1) Insert the key into the key cylinder, and turn the key to the ACC position.
(2) Insert a flat tip screwdriver from the steering lock frame hole (A), and pull the key cylinder until the key cylinder claws touch the steering lock frame stopper (B).
(3) Insert a flat tip screwdriver from the steering lock frame hole (A), and release the claws to pull out the key cylinder.
5. Release the claws and remove the ignition switch assembly.
Replacement
SECURITY AND LOCKS > Ignition Key LockREPLACEMENTCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG S ...
Other materials:
Dtc p0507 idle control system rpm - higher than expected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0507 IDLE CONTROL SYSTEM RPM - HIGHER THAN EXPECTEDDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine keeps running at higher speed than specified idl ...
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" 2-30.
2. Sit in the driver's seat and shut all
doors and the rear gate.
3. Turn the ignition switch to the "ON"
position.
...
Dtc p062f internal control module eeprom error
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P062F INTERNAL CONTROL MODULE EEPROM ERRORNOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCESSOR">1. OUT ...
