REAR SUSPENSION > Rear Trailing Link
DISASSEMBLY
1. BUSHING A - TRAILING LINK
Using the ST, push out the bushing A - trailing link.
Preparation tool:
ST-A: INSTALLER (899874100)
ST-B: INSTALLER & REMOVER (BASE) (20099PA010)
2. BUSHING - TRAILING LINK
For the removal procedure of bushing - trailing link, refer to “Rear Axle” in the “DRIVE SHAFT SYSTEM” section. Rear Axle > DISASSEMBLY">
Installation
CLUTCH SYSTEM > Clutch Disc and CoverINSTALLATION1. Insert the ST into the clutch disc and the ST end into pilot bearing to install the clutch disc.NOTE:When installing the clutch disc, be careful to attach in the correct direction.ST 499747100CLUTCH DISC GUIDE(A)Flywheel side2. Install the cl ...
Installation of child restraint systems by use of lower and tether
anchorages (LATCH)
WARNING
Child restraint systems and seatbelts
can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
Do not leave an unsecured child
restraint system in your vehicle.
...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion ValveINSTALLATIONCAUTION:Replace the O-rings with new parts, and then apply compressor oil.1. Install each part in the reverse order of removal.Tightening torque:Heater and cooling unit: General Description > COMPONENT">Air conditio ...