Subaru Crosstrek Service Manual: Disassembly
MECHANICAL(H4DO) > Cylinder Head
DISASSEMBLY
1. Remove the chain cover securing bolt from the cylinder head LH.
2. Remove the stud bolts from the cylinder head.
3. Remove the valve collet, valve, valve spring retainer, valve spring and valve spring seat from the cylinder head RH.
CAUTION:
During work, place a waste cloth, etc. to avoid scratching the mating surface of the cylinder head RH.
NOTE:
• Mark each part to prevent confusion.
• Keep all the removed parts in order for re-installing in their original positions.
(1) Compress the valve spring and remove the valve collet using ST.
| ST 0920287002000 | REMOVER AND REPLACER |
(2) Remove valve, valve spring retainer, valve spring and valve spring seat.
4. Remove the valve collet, valve, valve spring retainer, valve spring and valve spring seat from the cylinder head LH.
5. Remove the valve oil seals from valve guides of cylinder head RH.
CAUTION:
• During work, place a waste cloth, etc. to avoid scratching the mating surface of the cylinder head RH.
• Use special care not to damage the cylinder head RH and guide during work.
NOTE:
For removal of valve guide, refer to INSPECTION. Cylinder Head > INSPECTION">
6. For cylinder head LH, remove the valve oil seal in the same manner.
Removal
MECHANICAL(H4DO) > Cylinder HeadREMOVAL1. CYLINDER HEAD RH1. Remove the engine from the vehicle. Engine Assembly > REMOVAL">2. Remove the intake manifold. Intake Manifold > REMOVAL& ...
Inspection
MECHANICAL(H4DO) > Cylinder HeadINSPECTION1. CYLINDER HEAD1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sectio ...
Other materials:
Caution
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage the ...
Dtc c1721 yaw rate sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1721 YAW RATE SENSORDTC DETECTING CONDITION:Defective yaw rate & G sensorTROUBLE SYMPTOM:• ABS does not operate.• VDC does not operate.• Hill start assist does not oper ...
Replacement
CLUTCH SYSTEM > Clutch FluidREPLACEMENTCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.• Use new FMVSS No. 116 DOT3 or DOT4.• Cover the air bleeder wi ...
