MECHANICAL(H4DO) > Cam Carrier
DISASSEMBLY
1. CAM CARRIER RH
1. Loosen the bolts (front camshaft cap RH, intake center camshaft cap RH, intake rear camshaft cap RH, exhaust center camshaft cap RH, and exhaust rear camshaft cap RH) equally, a little at a time in numerical sequence as shown in the figure, and remove each camshaft cap.
NOTE:
Arrange camshaft caps in order so that they can be installed in their original positions.
2. Remove the intake camshaft RH and the exhaust camshaft RH from cam carrier RH.
3. Remove the filter from cam carrier RH.
4. Remove the liquid gasket from cam carrier RH and front camshaft cap RH, intake rear camshaft cap RH and exhaust rear camshaft cap RH.
2. CAM CARRIER LH
1. Loosen the bolts (front camshaft cap LH, intake center camshaft cap LH, intake rear camshaft cap LH, exhaust center camshaft cap LH and exhaust rear camshaft cap LH) equally, a little at a time in numerical sequence as shown in the figure, and remove each camshaft cap.
NOTE:
Arrange camshaft caps in order so that they can be installed in their original positions.
2. Remove the intake camshaft LH and the exhaust camshaft LH from cam carrier LH.
3. Remove the filter from cam carrier LH.
4. Remove the liquid gasket from cam carrier LH and front camshaft cap LH, intake rear camshaft cap LH and exhaust rear camshaft cap LH.
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyINSPECTION• Check each component for scratches, damage or other faults.• Using the ST, check the backlash of pinion gear.ST1 498247001MAGNET BASEST2 498247100DIAL GAUGESpecification:0.13 — 0.18 mm (0.0051 â ...
Dtc b2a05 left speaker/audio circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A05 LEFT SPEAKER/AUDIO CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:Speaker impedance is more than 10 k? for 100 ms. (Detached speaker connection, etc.)Trouble symptom:• ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the glove box. Glove Box > REMOVAL">3. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">4 ...