MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven Gear
DISASSEMBLY
1. Using the ST, remove the taper roller bearing (extension case side).
ST 498077000 | REMOVER |
(A) | Taper roller bearing (extension case side) |
2. Using ST1 and ST2, remove the taper roller bearing (transfer case side).
ST1 498077000 | REMOVER |
ST2 899864100 | REMOVER |
(A) | Taper roller bearing (transfer case side) |
Rear tie-down holes
Rear tie-down hole
The rear tie-down holes are located near
each of the jack-up reinforcements.
There is a plug in each rear tie-down hole.
To use the rear tie-down holes, remove
the plugs. After using the rear tie-down
holes, return the plugs to their original
places.
WARNING
...
Installation
AIRBAG SYSTEM > Side Airbag ModuleINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Make sure that the side airbag module ...
Dtc p0068 map/maf - throttle position correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0068 MAP/MAF - THROTTLE POSITION CORRELATIONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...