Subaru Crosstrek Service Manual: Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve
DISASSEMBLY
1. Cover the reverse check sleeve with cloth, and remove the snap ring by using screwdriver.
NOTE:
If the snap ring is deformed or the spring repulsive force is not enough, replace with a new snap ring.
(A) | Snap ring |
2. Remove the reverse check plate, reverse check spring, reverse check cam, return spring (5th-Reverse), reverse accent shaft, return spring cap, and return spring (1st-2nd).
(A) | Reverse check plate |
(B) | Reverse check spring |
(C) | Return spring (5th-Reverse) |
(D) | Reverse check cam |
(E) | Reverse accent shaft |
(F) | Return spring cap |
(G) | Return spring (1st-2nd) |
3. Remove the O-ring.
NOTE:
Be careful not to damage the adjusting shim between reverse check sleeve assembly and case.
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveASSEMBLY1. Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Revers ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSPECTION• Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.• Tu ...
Other materials:
Dtc u0423 invalid data received from instrument panel cluster control module
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0423 INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULEFailure counter diagnosis of combination meterNOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSPECTIONDisassembled parts should be washed with cleaning solvent first, then inspected carefully.1. BearingReplace the bearings in the following cases.• When the bearing balls, outer races and inner races are broken or rusty. ...
Installation
WIPER AND WASHER SYSTEMS > Rear Wiper MotorINSTALLATION1. Install each part in the reverse order of removal.2. Check that the mark on the cap - pivot wiper faces up, as shown in the figure.Tightening torque:Refer to “COMPONENT” of “General Description”. General Descriptio ...
