MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential Assembly
DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1. Remove the twelve bolts and remove hypoid driven gear.
(A) | Hypoid driven gear |
2. Drive out the straight pin from differential assembly toward hypoid driven gear side.
ST 899904100 | STRAIGHT PIN REMOVER |
3. Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.
(A) | Pinion shaft |
(B) | Differential bevel pinion |
(C) | Differential bevel gear |
(D) | Adjusting washer |
4. Using the ST, remove the taper roller bearing.
ST 899524100 | PULLER SET |
2. DIFFERENTIAL SIDE RETAINER
1. Remove the O-ring.
2. Remove the oil seal.
NOTE:
Remove it using a flat tip screwdriver wrapped with cloth or tape, etc.
Tire replacement
The wheels and tires are important and
integral parts of your vehicle's design;
they cannot be changed arbitrarily. The
tires fitted as standard equipment are
optimally matched to the characteristics
of the vehicle and were selected to give
the best possible combination of running
performance ...
Dtc p081a starter disable circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P081A STARTER DISABLE CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
Location
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and FuseLOCATIONMain fuse boxA/C relay(A)Relay & fuse boxFuse 15 A (blower motor relay)(B)Fuse 15 A (blower motor relay)(C)Fuse 7.5 A (A/C control panel, A/C relay, sub fan relay, pressure switch and blower motor relay)(D)Fuse 7.5 A (A/C contro ...