GLASS/WINDOWS/MIRRORS > Outer Mirror Assembly
DISASSEMBLY
CAUTION:
When removing the mirror - repair, be careful not to damage the back surface of mirror - repair with a flat tip screwdriver.
1. Operate the remote control mirror switch to face the mirror - repair upward.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the mirror - repair.
(1) Using a flat tip screwdriver, release the clip, and slide the mirror - repair downward to remove.
(2) Disconnect connectors. (Model with mirror heater and Subaru Rear Vehicle Detection system)
4. Release the claws, and then remove the cover - cap outer mirror lower.
5. Release the claws, and then remove the cover - cap outer mirror.
CAUTION:
Be careful not to apply excessive force when removing the cover - cap outer mirror, as the lower hooks may become damaged.
6. Remove the light assembly - side turn mirror. (Model with side turn signal light)
(1) Remove the screws and pull out the light assembly - side turn mirror to the front of the vehicle.
(2) Disconnect the connector and remove the light assembly - side turn mirror.
Removal
EXTERIOR/INTERIOR TRIM > Mud GuardREMOVAL1. Lift up the vehicle.2. Remove the wheels.3. Remove the screws and clips to remove the mud guard.(1)Under cover - front(2)Mud guard - front(3)Mud guard - rear ...
Preparation
1. Turn off the ignition switch.
2. Close all doors (including rear gate).
3. Press and hold the " "
button on the
access key. All doors (including rear gate)
will then be locked.
4. Keep the " " button
pressed, and
press the rear lock button within 5
seconds after step ...
To arm the system using access
key/remote transmitter
1. Close all windows and the moonroof (if
equipped).
2. Remove the key from the ignition
switch (models without "keyless access
with push-button start system")/turn the
push-button ignition switch to the "OFF"
position (models with "keyless access with
push-button start system").
3. Open ...