Subaru Crosstrek Service Manual: Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve Assembly
DISASSEMBLY
1. Remove the drain separator from the leak check valve assembly. Drain Separator > REMOVAL">
2. Disconnect the drain tube from the leak check valve assembly.
NOTE:
Disconnect the quick connector as shown in the figure.
3. Remove the bracket from the leak check valve assembly.
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Remove the rear exhaust pipe. Rear Ex ...
Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyINSPECTION1. CHECK SWITCHING VALVE1. Check the resistance between switching valve terminals.Terminal No.Standard1 a ...
Other materials:
Assembly
DRIVE SHAFT SYSTEM > Front Drive ShaftASSEMBLY1. Roll up a thick piece of paper to a size where the shaft can pass through, and affix with tape to form a cylinder.2. Attach a new O-ring on this cylinder.CAUTION:• Always use a new O-ring.• Be careful that the O-ring does not become scr ...
Disassembly
COOLING(H4DO) > Radiator Sub Fan and Fan MotorDISASSEMBLY1. Remove the clip which holds the sub fan motor connector onto the radiator sub fan shroud.2. Disconnect the radiator sub fan from the sub fan motor.3. Disconnect the sub fan motor from the radiator sub fan shroud. ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Motor Unit AssemblyREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground ...
