Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Disassembly

DRIVE SHAFT SYSTEM > Rear Drive Shaft

DISASSEMBLY

1. Remove the outer race (DOJ) from the shaft assembly.

CAUTION:

Be careful not to damage the boot.

(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).

CAUTION:

Be careful not to damage the boot.

(2) Remove the boot band on the small end of boot (DOJ) in the same manner.

(3) Remove the large end of boot (DOJ) from outer race (DOJ).

(4) Remove the round snap ring at the neck of outer race (DOJ) with a flat tip screwdriver.

(5) Remove the outer race (DOJ) from the shaft assembly.

(6) Wipe off the grease and take out the ball bearings.

CAUTION:

The grease is a special grease (grease for constant velocity joints). Do not mix with other greases.

NOTE:

Disassemble the parts taking care not to lose balls.

(A)

Outer race (DOJ)

(B)

Grease

2. Remove the cage from the inner race.

(1) Turn the cage by a half pitch to the track groove of inner race and shift the cage.

(2) Using pliers, remove the snap ring fixing the inner race to the shaft.

(3) Take out the inner race.

(4) Remove the cage from the shaft and remove the boot (DOJ).

CAUTION:

Wrap shaft splines with vinyl tape to protect the boot from scratches.

3. Remove the boot (BJ) or boot (EBJ) in the same procedure as the boot (DOJ).

NOTE:

Further disassembly of the drive shaft is impossible because the BJ and EBJ cannot be disassembled.

Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not ...

Inspection
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. Repair or replace if defective.• DOJ (Double Offset Joint):Check for seizure, corrosion ...

Other materials:

Towing
If towing is necessary, it is best done by your SUBARU dealer or a commercial towing service. Observe the following procedures for safety. WARNING Never tow AWD models with the front wheels raised off the ground while the rear wheels are on the ground, or with the rear wheels raised off t ...

Installation
MECHANICAL(H4DO) > Timing Chain AssemblyINSTALLATION1. TIMING CHAIN LHNOTE:• Be careful that the foreign matter is not into or onto the assembled component during installation.• Apply engine oil to all component parts of the timing chain.1. Prepare to attach the chain tensioner LH.(1) ...

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSPECTION1. Check that the front oxygen (A/F) sensor has no deformation, cracks or other damages.2. Measure the resistance between front oxygen (A/F) sensor terminals.Terminal No.Standard1 and 22.0+0.42 −0.2 ? (when 20&#x00 ...

© 2016-2025 Copyright www.sucross.com