DRIVE SHAFT SYSTEM > Rear Axle
DISASSEMBLY
1. BUSHING - REAR AXLE HOUSING
Do not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.
2. REAR BUSHING
1. Remove the rear axle housing. Rear Axle > REMOVAL">
2. Using the ST and a hydraulic press, push out the bushing.
Preparation tool:
ST1: BUSHING REMOVER (20099FG000)
ST2: INSTALLER & REMOVER (BASE) (20099PA010)
(1) | Rear axle housing | (2) | Rear bushing |
Dtc c1424 ecm
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1424 ECMDTC detecting condition:ECM malfunctioningTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.STEPCHECKYESNO1.CHECK E ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower MotorINSPECTION1. Check the motor operation when battery voltage is applied between the terminals of motor.Terminal No.Inspection conditionsSpecificationConnection diagram2 (+) — 1 (−)Connect battery to the terminalsRotation2. If it does n ...
Removal
AIRBAG SYSTEM > Curtain Airbag ModuleREMOVAL1. CROSSTREK MODELCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2. ...