Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Disassembly

DRIVE SHAFT SYSTEM > Front Hub Unit Bearing

DISASSEMBLY

Using the ST or a hydraulic press, push out the hub bolt (b) from the front hub unit bearing (a).

CAUTION:

Be careful not to hammer the hub bolts. This may deform the hub unit bearing.

Do not reuse the hub bolt.

NOTE:

Since the hub unit bearing can not be disassembled, only hub bolts can be removed.

Preparation tool:

ST: HUB STAND (28399AG000)

Removal
DRIVE SHAFT SYSTEM > Front Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. ...

Inspection
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSPECTION1. Moving the front tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is u ...

Other materials:

Tool locations
Jack handle Tool bucket Spare tire Wheel nut wrench Screwdriver Jack Towing hook (eye bolt) A jack handle is stored under the floor of the cargo area. A jack and a towing hook are stored in the tool bucket that is located in the recess of the spare tire wheel. Als ...

Specification
WIPER AND WASHER SYSTEMS > General DescriptionSPECIFICATIONFront wiper motorInput12 V — 72 W or lessRear wiper motorInput12 V — 42 W or lessFront washer motorPump typeCentrifugalInput12 V — 60 W or lessRear washer motorPump typeCentrifugalInput12 V — 36 W or less ...

Dtc p081a starter disable circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P081A STARTER DISABLE CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...

© 2016-2025 Copyright www.sucross.com