Subaru Crosstrek Service Manual: Disassembly
CONTROL SYSTEMS > Select Lever
DISASSEMBLY
1. GRIP ASSY
1. Remove the button assembly_AT.
(A) | Claw |
2. Remove the rod COMPL.
2. AT SELECT LEVER ASSEMBLY
1. Remove the spacer plate.
2. Remove the gasket.
3. Insert a flat tip screwdriver with a thin tip under the connector and disconnect the harness connector from the plate COMPL.
4. Remove the harness from the plate COMPL.
5. Raise the claw with a flat tip screwdriver with a thin tip and remove the solenoid unit.
6. Remove the terminal of the solenoid unit using a flat tip precision screwdriver with a tip width of 1.3 mm (0.05 in) or less, KTC connector terminal tool ECC-1T or equivalent.
(A) | Solenoid unit terminals |
7. Remove the clamp push nut.
NOTE:
Replace the clamp push nut with a new part.
8. Pull out shaft control.
9. Remove the clamp push nut.
NOTE:
Replace the clamp push nut with a new part.
10. Pull out spacer pin guide.
11. Remove the clamp pin.
12. Remove the spacer pin guide.
13. Remove the select lever COMPL from the plate COMPL.
14. Remove the arm COMPL.
(A) | Arm COMPL |
(B) | Select lever COMPL |
15. Remove the plate guide from the select lever COMPL.
16. Remove the rod detent and detent spring from the select lever COMPL.
3. INDICATOR ASSY
1. Remove the boot assembly from the indicator assembly.
CAUTION:
When removing the boot assembly, be careful not to damage the boot assembly claws and adjacent parts.
Removal
CONTROL SYSTEMS > Select LeverREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect th ...
Inspection
CONTROL SYSTEMS > Select LeverINSPECTION1. Inspect the removed parts by comparing with new parts for deformation, damage and wear. Repair or replace if defective.2. Inspect the select lever assembl ...
Other materials:
Inspection
INSTRUMENTATION/DRIVER INFO > Steering SwitchINSPECTION1. Measure the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 2 (UP)i/SET (DOWN)All OFFApprox. 1 M? or more (UP)ONLess than 1 ?i/SETONApprox. 1,000 ? (DOWN)ONApprox. 3,670 ?2. ...
Dtc b2327 rear radar internal failure (internal electric circuit)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2327 REAR RADAR INTERNAL FAILURE (INTERNAL ELECTRIC CIRCUIT)DTC DETECTING CONDITION:Defective radar sensorTROUBLE SYMPTOM:• All functions of BSD/RCTA stop.• Fail i ...
Wiring diagram
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAM(1)Battery(5)Engine control module (ECM)(9)Torque sensor (main & sub)(2)Ignition switch(6)Power steering control module(10)CAN communication(3)STEERING warning light (combination meter)(7)Motor(11)VD ...