CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Case
DISASSEMBLY
1. Remove the oil stopper plate.
2. Remove all plugs from the transmission case.
3. Remove the oil seal using a screwdriver wrapped with cloth etc.
4. Using the ST, remove the ball bearing of the secondary pulley.
(1) Remove the claw of ST1, and attach the claw of ST2.
ST1 398527700 | PULLER ASSY |
ST2 18760AA000 | CLAW |
(A) | Claw |
(2) Using the ST, remove the ball bearing of the secondary pulley.
ST1 398527700 | PULLER ASSY |
ST2 18760AA000 | CLAW |
5. Remove the oil guide.
6. Remove the ball bearing from reduction driven gear using ST.
ST 398527700 | PULLER ASSY |
7. Remove the CVTF filter cover and gasket.
8. Remove the CVTF filter.
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY N-130 or the equivale ...
Dtc p0013 "b" camshaft position actuator control circuit/open bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0013 "B" CAMSHAFT POSITION ACTUATOR CONTROL CIRCUIT/OPEN BANK 1DTC detecting condition:Immediately at fault recognitionTrouble symptom:Improper idlingCAUTION:After servicing or replacing faulty part ...
Caution
POWER ASSISTED SYSTEM (POWER STEERING) > General DescriptionCAUTION• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary re ...