CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Clutch
DISASSEMBLY
1. Remove the snap ring, and then remove the pressure plate, drive plate and driven plate.
(A) | Snap ring |
2. Compress the return spring using the ST to remove the snap ring.
ST 18762AA001 | COMPRESSOR SPECIAL TOOL |
(A) | Snap ring |
(B) | Transfer clutch piston seal |
3. Remove the transfer clutch piston seal.
4. Remove the return spring.
5. Remove the transfer clutch piston by blowing compressed air through transfer clutch assembly hole.
NOTE:
Plug the holes through which the compressed air is not blown.
6. Remove the ball bearing using ST.
ST1 18767AA010 | BEARING REMOVER |
ST2 18723AA000 | REMOVER |
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyADJUSTMENT1. Remove the liquid gasket from the mating surface completely.2. Using the ST, install the drive pinion retainer to converter case.ST 18270KA020SOCKET (E20)NOTE:Do not confuse the three different-length bolts whe ...
Dtc p0354 ignition coil "d" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0354 IGNITION COIL "D" PRIMARY CONTROL CIRCUIT/OPENNOTE:For the diagnostic procedure, refer to DTC P0351. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0351 IGNITION COIL " ...
Dtc b1576 egi control module eeprom
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1576 EGI CONTROL MODULE EEPROMDTC detecting condition:• ECM malfunctioning• When the ROM in ECM was inaccessible during registration.STEPCHECKYESNO1.PERFORM ECM REG ...