Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Disassembly

CLUTCH SYSTEM > Operating Cylinder

DISASSEMBLY

1. Remove the boot and push rod.

2. Apply compressed air through clutch hose attachment hole.

NOTE:

Face the piston hole down and place a piece of wood underneath to prevent the piston from popping out.

3. Separate the piston and piston spring.

Removal
CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconne ...

Inspection
CLUTCH SYSTEM > Operating CylinderINSPECTION1. Check that the operating cylinder is not damaged. Replace the operating cylinder if it is damaged.2. Check the brake fluid leakage on the operating cy ...

Other materials:

Component
EXTERIOR BODY PANELS > General DescriptionCOMPONENT1. FRONT HOOD(1)Hood COMPL - front(6)Stopper - front hoodTightening torque: N·m (kgf-m, ft-lb)(2)Hinge COMPL - front hood(7)Stay - hood supportT1:25 (2.55, 18.4)(3)Cover - front fender(8)Seal - front ductT2:33 (3.36, 24.3)(4)Insulator - fr ...

Removal
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorREMOVAL1. BATTERY CURRENT SENSORNOTE:Remove the battery current sensor and battery cable as a unit.1. Disconnect the battery ground cable and remove the clip from the battery rod.2. Remove the battery terminal boot.3. Remov ...

Procedure
DIFFERENTIALS > Rear Differential Inspection ModePROCEDURECAUTION:Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.1. Shift the select lever to “P” range.2. Apply the parking brake.3. Lift up the vehicle.WARNING:Lift up ...

© 2016-2022 Copyright www.sucross.com