BRAKE > Master Cylinder
DISASSEMBLY
1. Remove the reservoir tank.
CAUTION:
Be careful not to tighten a vise excessively.
(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.
(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.
2. Remove the seal from the cylinder body assembly.
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle BodyREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL">4. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Engine Coolant > REPLACEMENT"& ...
Electrical specification
SECURITY AND LOCKS > Keyless Entry SystemELECTRICAL SPECIFICATION1. KEYLESS ENTRY CONTROL MODULE• Model without tire pressure monitoring systemTerminal No.ItemMeasuring conditionStandard3 (U-ART com.) — Cannot be measured — 4 (+B) ←> Chassis groundVoltageAlways10 — 14 V7 (GND) ...
Inspection
CONTROL SYSTEMS > AT Shift Lock Control SystemINSPECTION1. SHIFT LOCK OPERATION• Model without push button ignition switchSTEPCHECKYESNO1.CHECK COMMUNICATION OF SUBARU SELECT MONITOR.1) Turn the ignition switch to ON.2) Using the Subaru Select Monitor, check whether communication to all sys ...