Perform either of the following procedures.
Briefly press the disarm button (for less than 2 seconds) on the access key/remote transmitter.
Carry the access key and perform either of the following procedures (models with "keyless access with push-button start system").
The following door(s) will unlock, an electronic chirp will sound twice and the hazard warning flashers will flash twice.
Driver's door: when either of the following procedures is performed
Rear gate: when pressing the rear gate opener button (models with "keyless access with push-button start system")
All doors: when gripping the front passenger's door handle (models with "keyless access with push-button start system")
The flashing of the security indicator light will then change slowly (once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed.
To unlock all other doors and the rear gate, briefly press the disarm button a second time within 5 seconds.
Emergency disarming
If you cannot disarm the system using the access key/transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the access key/remote transmitter.
The system can be disarmed if you turn the ignition switch from the "LOCK"/"OFF" to the "ON" position with a registered key/ access key.
NOTE
For models with "keyless access with push-button start system", if the access key battery is discharged, perform the procedure described in "Switching power status" 9-17. In such a case, replace the battery immediately. Refer to "Replacing battery of access key" 11-42.
Windows
WARNING
To avoid serious personal injury
caused by entrapment, always conform
to the following instructions
without exception.
When operating the power windows,
be extremely careful to
prevent anyone's fingers, arms,
neck, head or other objects from
being caught in the window.
Alwa ...
Dtc c1811 system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1811 SYSTEMDTC detecting condition:ABS and VDC long time sequential controlTrouble symptom:• ABS does not operate.• VDC does not operate.• EBD may not operate.• Hill ...
Installation
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)INSTALLATION1. MODELS WITHOUT EyeSightCAUTION:• When installing the VDCCM&H/U to the bracket - hydraulic unit, make sure that there is no oil adhered to the bolts and the threads of VDCCM&H ...