Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Differential gear oil

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF FilterINSTALLATIONNOTE:For installation of CVTF filter, refer to “Transmission Case”. Transmission Case > ASSEMBLY"> Transm ...

Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Differential Gear OilADJUSTMENTNOTE:Immediately after removing the overflow drain plug, remaining gear oil (approx. 8 cc) may come out of the overflow pi ...

Other materials:

Checking the oil level
1. Park the vehicle on a level surface and turn the ignition switch to the "LOCK"/ "OFF" position. If you check the oil level just after turning the ignition switch to the "LOCK"/"OFF" position, wait a few minutes for the oil to drain back into the oil pan before checking the level. Oi ...

State emission testing (U.S. only)
WARNING When performing emission testing on a Subaru Ascent equipped with All-Wheel Drive (AWD), only a four-wheel dynamometer must be used. Under no circumstances should the Subaru Ascent be tested on a two-wheel dynamometer. Doing so can cause uncontrolled wheel rotation, leading to danger ...

Engine control module (ecm) i/o signal Electrical specification
ENGINE (DIAGNOSTICS)(H4DO) > Engine Control Module (ECM) I/O SignalELECTRICAL SPECIFICATION1. ENGINE CONTROL MODULE (ECM)DescriptionConnector No.Terminal No.Signal (V)NoteIgnition SW ON(Engine OFF)Engine ON(Idling)Crankshaft position sensor(+) signalB1361650 or 5Waveform*(−) signalB1362700 ...

© 2016-2026 Copyright www.sucross.com