Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostics with Phenomenon
INSPECTION
Symptoms | Maintenance parts |
BSD/RCTA does not operate. | Fuse |
LAN system Basic Diagnostic Procedure"> | |
Body control system Basic Diagnostic Procedure"> | |
Radar sensor LH | |
Radar sensor RH | |
BSD/RCTA cannot be turned OFF. | BSD/RCTA OFF switch |
LAN system Basic Diagnostic Procedure"> | |
Body control system Basic Diagnostic Procedure"> | |
Radar sensor LH | |
Error message appears in the combination meter. | CHECK CANCEL CODE. Read Cancel Code"> |
Radar sensor LH | |
Radar sensor RH | |
Combination meter Basic Diagnostic Procedure"> | |
Outer mirror assembly (LH) indicator does not illuminate. | Outer mirror assembly Outer Mirror Assembly"> |
Radar sensor LH | |
Outer mirror assembly (RH) indicator does not illuminate. | Outer mirror assembly Outer Mirror Assembly"> |
Radar sensor RH | |
Outer mirror assembly (LH) indicator remains on. | Radar sensor LH |
Outer mirror assembly (RH) indicator remains on. | Radar sensor RH |
Outer mirror assembly (LH) indicator does not blink. | Radar sensor LH |
Outer mirror assembly (RH) indicator does not blink. | Radar sensor RH |
Outer mirror assembly (LH) indicator keeps blinking. | Radar sensor LH |
Outer mirror assembly (RH) indicator keeps blinking. | Radar sensor RH |
Dtc b1795 occupant detection module internal circuit
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1795 OCCUPANT DETECTION MODULE INTERNAL CIRCUITDIAGNOSIS START CONDITION:Ignition voltage is 8 V to 16 V.DTC DETECTING CONDITION:Occupant detection control module is faulty.When “DTC B1795 ...
Dtc p0302 cylinder 2 misfire detected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0302 CYLINDER 2 MISFIRE DETECTEDNOTE:For the diagnostic procedure, refer to DTC P0304. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0304 CYLINDER 4 MISFIRE DETECTED">1. OUTLINE O ...
If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations
Press any button on the access key/
remote transmitter.
Turn the ignition switch to the "ON"
position (models without "keyless access
with push-button start system").
Turn the push-button ignition to the
"ACC" position (models wit ...