Subaru Crosstrek Service Manual: Diagnostics with phenomenon Inspection
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostics with Phenomenon
INSPECTION
Symptoms | Faulty parts |
Engine stalls when driving in “D” or “R” range, or selecting “N” > “D”, “N” > “R”. |
• Control valve
• Engine control system
While driving in “D” range, vibration occurs immediately before the stop or engine stalls.
• Control valve
• Torque converter
Vehicle cannot shift while driving in “D” range.
• Control valve
• TCM
• Shift mechanism
• Power supply system
Excessive shock when selecting “N” > “D”, and “N” > “R”.
• Control valve
• TCM
• F&R clutch pack
• ATF deterioration or lack
Excessive shock at standing start in “D” range.
• Control valve
• TCM
• F&R clutch pack
• ATF deterioration or lack
Engine speed increases abruptly during driving in “D” or “R” range.
• Control valve
• Secondary pressure sensor
• F&R clutch pack
• ATF deterioration or lack
Vehicle can not start when depressing the accelerator pedal in “D” or “R” range, or acceleration is very poor. (without abrupt engine increase)
• Control valve
• F&R clutch pack
• Shift mechanism
• Parking mechanism
• Engine control system
• Power supply system
Shift indicator in combination meter displays the position which differs from select lever position.
• Inhibitor switch
• Select cable related
• Combination meter
Manual mode enters even though the select lever and paddle shift switch is not operated.
• Manual mode switch
• Paddle shift switch
• Select lever
• TCM
Engine speed increases abruptly in “D” or “R” range, vehicle can not start.
• F&R clutch pack
• Select cable related
Manual mode can not be set
• Select lever
• TCM
Diagnostic procedure without diagnostic trouble code (dtc) Check shift indicator
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure without Diagnostic Trouble Code (DTC)CHECK SHIFT INDICATORDiagnosis:• CAN communication is abnormal with the combinatio ...
Drive cycle Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Drive CyclePROCEDUREIt is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform ...
Other materials:
Fuel Procedure
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > FuelPROCEDURE1. RELEASING OF FUEL PRESSUREWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:Be careful not to spill fuel.1. Remove the fuse of fuel pump from main fuse box.2. Start the engine and run it until it stalls.3. After th ...
Dtc b27a2 passenger side external antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A2 PASSENGER SIDE EXTERNAL ANTENNA OPENDTC detecting condition:When open circuit occurs in the harness between keyless access CM and passenger’s side front door outer h ...
Interruption screen
Warning information (display example)
Useful messages, such as reminder information,
vehicle information, warning
information, etc. may interrupt the current
screen and appear on the display accompanied
by a beep. Take proper action
according to the message.
The warning screen will retu ...
