Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0101 lost communication with tcm
- Dtc u0073 control module communication bus off
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc b2300 rear radar circuit low
- Dtc b2301 rear radar circuit high
- Dtc b2304 rear radar on-off switch stuck
- Dtc b2311 rear radar detect tcm
- Dtc b2313 rear radar detect vdc
- Dtc b2327 rear radar internal failure (internal electric circuit)
- Dtc b2329 rear radar axis alignment incomplete
- Dtc b2350 rear radar communication error between master and slave
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0402 invalid data received from tcm
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0422 invalid data received from body control module
- Dtc u0423 invalid data received from instrument panel cluster control module
Wiring diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAMRefer to “BSD/RCTA System” in the wiring diagram. Blind Spot Detection/Rear Cross T ...
Dtc u0101 lost communication with tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not ar ...
Other materials:
Two separate circuits
Your vehicle has two separate circuit
brake systems. Each circuit works diagonally
across the vehicle. If one circuit of
the brake system should fail, the other half
of the system still works. If one circuit fails,
the brake pedal will go down much closer
to the floor than usual and you will n ...
Preparation for date setting
Turn the ignition switch to the "ON"
position.
Push and hold the button to show
the selection screen.
After the selection screen is displayed,
operate the "
"
or "
" switch to show the
"Time/Date" item. Then, push the
button.
...
Inspection
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSPECTION1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ignition switch to ON. (Engine OFF)3. Measure the voltage between ECM connector terminals.• Main ...
