Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Defogger setting

1. Perform the preparation steps according to "Preparation for car settings"

Defogger setting

2. Operate the " " or "  " switch to select the "Defogger" item. Then push the button.

Defogger setting

3. The current setting will be displayed.

Push the  button to enter the selection mode.

Defogger setting

4. Select the preferred setting by operating the "  " or "  " switch. Then push the button.

Defogger setting

5. Select "Set" by operating the " " switch, and confirm the setting by pushing the  button.

Defogger setting

6. The system will notify you that the setting is complete.

If the setting is not available, the following notification will be displayed. In this case, perform the setting procedure again.

Defogger setting

Hazard warning flasher setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or " " switch to select the "Hazard Warning Flasher" item.Then push the button. 3. The curr ...

Interior light off delay timer setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or " " switch to select the "Interior Light" item. Then push the  button. 3. The cu ...

Other materials:

Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">3. Remove the trim panel - roof assembly. Roof Trim &g ...

Preparation tool
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > General DescriptionPREPARATION TOOL1. GENERAL TOOLTOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current.Hexagon wrenchUsed for forcibly driving the motor assembly - sunroof. Width across flat 4 mm (0.16 in)TORX® T25Used for rem ...

Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. Install the inner race to the shaft.(1) Install the boot (BJ) or boot (EBJ) in the specified position, ...

© 2016-2025 Copyright www.sucross.com