CRUISE CONTROL SYSTEM > Cruise Control System
NOTE
For operation procedures of each component of the cruise control system, refer to the respective section.
• Control module: Control Unit">
NOTE:
System control of the cruise control is performed by each module. For procedure, refer to the following sections.
– Engine control module (ECM): Engine Control Module (ECM)">
– Transmission control module (TCM): Transmission Control Module (TCM)">
• Cruise control command switch: Cruise Control Command Switch">
• Combination meter: Combination Meter">
• Stop light and brake switch: Stop Light Switch">
• Clutch switch: Clutch Switch">
• Inhibitor switch: Inhibitor Switch">
• Neutral position switch: Switches and Harness">
CRUISE CONTROL SYSTEM > General Description
LOCATION
Refer to “LOCATION” of “CRUISE CONTROL SYSTEM (DIAGNOSTICS)” section. Electrical Component Location > LOCATION">
Cruise control command switch
Clutch switch NoteAuto light sensor sensitivity setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Auto Light Sensor" item. Then
push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Selec ...
Preparation tool
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Se ...
General diagnostic table Inspection
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > General Diagnostic TableINSPECTIONSymptomsMain probable causeOther probable causePoor brake performanceLong braking/stopping distance• VDCCM&H/U• Brake pad• Aeration to brake line• Tire specifications, tire wear and air pr ...