Subaru select monitor OperationRemoval
INTAKE (INDUCTION)(H4DO) > Air Cleaner CaseREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B).4. ...
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass LidREMOVAL1. GLASS LID1. Completely close the lid assembly - sunroof, and open the sunshade assembly.2. Remove the TORX® bolt, and then remove the lid assembly - sunroof.CAUTION:Be careful not to damage the lid assembly - sunroof.PREPARATION TOOL:T ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...