Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Continuously variable transmission

Subaru Crosstrek Owners Manual / Starting and operating / Continuously variable transmission

WARNING

Do not shift from the "P" or "N" position into the "D" or "R" position while depressing the accelerator pedal. This may cause the vehicle to jump forward or backward.

CAUTION

Observe the following precautions.

Failure to observe these precautions could cause damage to the transmission.

Do not race the engine for more than 5 seconds in any position except the "N" or "P" position when the brake is applied or when chocks are used in the wheels. This may cause the transmission fluid to overheat.

Never move the vehicle rearward by inertia with the select lever set in a forward driving position or move the vehicle forward by inertia with the select lever set in the "R" position. Doing so may result in an unexpected accident or malfunction.

When parking the vehicle, first securely apply the parking brake and then place the select lever in the "P" position. Do not park for a long time with the select lever in any other position as doing so could result in a dead battery.

Driving tips
Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions may cause clutch damage. Do not dri ...

Continuously variable transmission features
The continuously variable transmission is electronically controlled and provides an infinite number of forward speeds and 1 reverse speed. It also has a manual mode. NOTE When the engine coola ...

Other materials:

Tilt/telescopic steering wheel
WARNING Do not adjust the steering wheel tilt/telescopic position while driving. This may cause loss of vehicle control and result in personal injury. If the lever cannot be raised to the fixed position, adjust the steering wheel again. It is dangerous to drive without locking ...

Removal
EXTERIOR BODY PANELS > Front HoodREMOVAL1. FRONT HOOD PANELCAUTION:The hood COMPL - front is heavy. When removing or installing the hinge COMPL - front hood, be sure to work in a group of two or more.1. Open the hood COMPL - front.2. Remove the clips, and remove the insulator - front hood.3. Remo ...

Dtc b1638 curtain airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1638 CURTAIN AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (LH) ...

© 2016-2024 Copyright www.sucross.com