MECHANICAL(H4DO) > Compression
INSPECTION
CAUTION:
After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.
1. Turn the ignition switch to OFF.
2. After warming-up the engine, turn the ignition switch to OFF.
3. Make sure that the battery is fully charged.
4. Check the starter motor for satisfactory performance and operation.
5. Remove the fuse of fuel pump from main fuse box.
6. Start the engine and run it until it stalls.
7. After the engine stalls, crank it for five more seconds.
8. Turn the ignition switch to OFF.
9. Remove all spark plugs. Spark Plug > REMOVAL">
10. Install the compression gauge to the spark plug hole.
NOTE:
When using a screw-in type compression gauge, the screw should be less than 25 mm (0.98 in) long.
11. Connect the battery ground terminal. NOTE">
12. Turn the ignition switch to ON.
13. Depress the accelerator pedal to full throttle.
14. Crank the engine by starter motor and read the value when the needle of the compression gauge becomes stable.
NOTE:
• Perform at least two measurements per cylinder, and make sure that the values are correct.
• If the compression pressure is out of standard, check or adjust the pistons, valves and cylinders.
Compression pressure (at 200 — 300 r/min):
Standard
1,050 — 1,400 kPa (11 — 14 kg/cm2, 152 — 203 psi)
Difference between cylinders
100 kPa (1 kg/cm2, 14 psi) or less
15. After inspection, install the related parts in the reverse order of removal.
Dtc c1332 rr pressure reducing valve
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1332 RR PRESSURE REDUCING VALVENOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C ...
Electrical component location Location
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Engine control module (ECM)(4)Cruise indicator light and cruise set indicator light(7)Neutral position switch (MT model)(2)Cruise control command switch(5)Transmission control module (TCM) (CVT model)(8)Clutch switch (M ...
Specification
IGNITION(H4DO) > General DescriptionSPECIFICATIONItemSpecificationsIgnition coilManufacturer and typeHitachi: EIC-2230Ignition systemIndependent ignition coilSpark plugManufacturer and typeNGK: SILZKAR7B11Thread size (diameter, pitch, length)mm12, 1.25, 26.5Spark plug gapmm (in)Standard1.0 — 1. ...