General diagnostic table InspectionInspection
SECURITY AND LOCKS > Push Button Ignition SwitchINSPECTION1. Check the continuity between push button ignition switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsSpecification4 (COM) — 5 (GND)AlwaysContinuity exists7 (SSW1) — 5 (GND)Push button ignition switch re ...
Removal
EXTERIOR/INTERIOR TRIM > Console BoxREMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:On CVT models, shift the select lever into “N” before disconnecting the battery ground cable.2. Remove the console box assembly.(1) Release the claws, and then remove the boot - ...
Installation
CONTROL SYSTEMS > MT Gear Shift LeverINSTALLATION1. Insert the gear shift lever from the room side.NOTE:Insert the rod and the stay, and then temporarily set them onto the transmission mount.2. Lift up the vehicle.3. Install the joint to the transmission and secure with a spring pin.(A)Joint(B)Sp ...