KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Subaru Select Monitor
COMMUNICATION FOR INITIALIZING IMPOSSIBLE
NOTE:
Confirm that the LAN system is working properly before the diagnosis.
Subaru Select Monitor communication line is open or shorted.
Detecting condition:
• Defective harness
• Power supply circuit malfunction
• Defective keyless access CM
• Defective CAN communication circuit
• Defective Subaru Select Monitor
Trouble symptom:
Not communicable with Subaru Select Monitor.
Wiring diagram:
• Push button start system Push Button Start System > WIRING DIAGRAM">
• CAN communication system CAN Communication System > WIRING DIAGRAM">
STEP | CHECK | YES | NO |
1.CHECK OTHER COMMUNICATION.
Communicate with the system other than the keyless access system using the Subaru Select Monitor.
Is the communication to other control module possible?
Subaru Select Monitor > COMMUNICATION FOR INITIALIZING IMPOSSIBLE">Go to Step 2.
Perform the “Communication for Initializing Impossible” of LAN system. Subaru Select Monitor > COMMUNICATION FOR INITIALIZING IMPOSSIBLE">
2.CHECK DTC.
Read the DTC of the LAN system using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is DTC detected?
Perform the diagnosis according to DTC.
Subaru Select Monitor > COMMUNICATION FOR INITIALIZING IMPOSSIBLE">Go to Step 3.
3.CHECK KEYLESS ACCESS CM.
1) Turn the ignition switch to OFF.
2) Disconnect the keyless access CM connector.
3) Connect the disconnected connectors.
4) Perform communication with the keyless access system using the Subaru Select Monitor.
Is communication possible?
It is possible that temporary poor communication occurs.
Replace the keyless access CM. Keyless Access CM">
CAUTION:
For replacement procedure of keyless access CM, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Check list for interview Check
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Combination Meter / MFD Check List for Interview Date the ...
Removal
MECHANICAL(H4DO) > Timing Chain AssemblyREMOVAL1. TIMING CHAIN RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. Remove the chain cover. Chain Cover > REMOVAL">2. Using ST and by turning the crankshaft, align the alignment marks of cra ...
Starting the engine
NOTE
All vehicle doors (including rear gate)
and the engine hood must be closed
prior to activating the remote engine
start system. Any open entry point will
prevent starting or cause the engine to
stop.
The remote engine start system is activated
by pressing the fob button on your
remote e ...