Subaru Crosstrek Service Manual: Combination meter Note
Blind Spot Detection/Rear Cross Traffic Alert > Combination Meter
NOTE
For the operation procedures for combination meter, refer to “INSTRUMENTATION/DRIVER INFO” section. Combination Meter">
Blind spot detection/rear cross traffic alert
Note
Blind Spot Detection/Rear Cross Traffic Alert > Blind Spot Detection/Rear Cross Traffic AlertNOTEFor procedure of each component in the Subaru Rear Vehicle Detection system, refer to the resp ...
Diagnostics with phenomenon Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Diagnostics with PhenomenonINSPECTIONRefer to “Diagnostics with Phenomenon” of “Blind Spot Detection/Rear Cross Traffic Alert (DIAG ...
Other materials:
Airbag connector Procedure
AIRBAG SYSTEM > Airbag ConnectorPROCEDURE1. POWER SUPPLY1. How to disconnect:CAUTION:When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.(1) Push the lock (a).(2) While holding down the lock (a), disconnect the connector.2. How to connect:CAUTION ...
Caution
COOLING(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cove ...
Dtc u0126 lost communication with steering angle sensor module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0126 LOST COMMUNICATION WITH STEERING ANGLE SENSOR MODULEDTC DETECTING CONDITION:No data is received from steering angle sensor.TROUBLE SYMPTOM:VDC CM does not operate normally.STEPCHECKYESNO1.CHECK PERFORMING ...
